|
|
Most of the battery chargers manufactured by Analytic Systems can be adapted for military use (COTS - Commercial Off The Shelf).
Commonly, military battery chargers will use extra-wide temperature range components to allow operation to -40 degrees Celsius and the printed circuit boards will be dipped in silicone conformal coating for protection against condensation and enhanced vibration protection. Additional RTV Silicone will be used on specific components for additional vibration protection. This level of vibration protection meets or exceeds MIL-PRF-44485.
If you have a specific application and need help determining which Analytic military battery charger is right for you, please CONTACT US, or Phone us (Toll-Free) at
1-800-668-3884.
|
|
|
The following are specific products designed and manufactured for charging Military Batteries:
|
Military Battery Chargers - MIL-STD |
BCA650-MS |
The BCA650 Battery Charger operates from any 110 Volt AC source. It meets MIL-PRF-44485 for vibration and MIL-461E for both radiated and conducted noise and can withstand rainfall at 4 inches per hour. It produces 26 charging volts DC and 24 amps continuous at up to 50 degrees C, and has a peak current of 45 charging amps.
<Spec Sheet> <Request More Info> |
LIAC600-MS |
The LIAC600 is a COTS Charger designed to recharge the SAFT Lithium-Ion Battery (LBB) used by the US Armed Forces and is controlled using industry standard interface circuitry. It can also be used in Bypass Mode as a Stand-Alone power supply. It delivers 32.0 VDC at up to 22 amps continuous to quickly recharge batteries. The output charges to 28 VDC at up to 22 amps when operating in Bypass Mode.
NATO STOCK NUMBER #NSN-6130-20-002-2433
<Spec Sheet> <Request More Info> |
|
The BCA1510 Battery Charger provides up to 700 watts to charge a 12, 24 or 24 Volt battery system (1 bank) from a 110 or 220VAC source. This all-new single board design incorporates state of the art switchmode technology for unmatched efficiency and ultra-quiet operation. This unit is also encased in a water-tight chassis.
<Spec Sheet> <Request More Info> |
DC/DC Military Battery Chargers - MIL-STD |
LIDC600-MS |
The LIDC600 COTS DC/DC Battery Charger is designed for recharging the SAFT Lithium Ion Battery (LBB) used by the US Armed forces from a 24V DC source such as a HumVee, and is controlled using industry standard interface circuitry. It can also be used in Bypass Mode as a Stand-Alone DC-DC voltage converter. It is designed to deliver 32.0 VDC at up to 22 amps continuous to recharge the battery. The output changes to 28 VDC at up to 22 amps continuous when operating in Bypass Mode.
<Spec Sheet> <Request More Info>
|
MBU Battery Pack
|
The MBU Portable Battery Pack produces a regulated 26 volts for running US Army cookstoves in the absence of AC power from a pair of sealed VLRA batteries. When the batteries need recharging, the Battery Pack is plugged into the auxiliary 24 volt power outlet on a HumVee and it recharges the batteries using a 3 stage temperature compensated charging algorithm. It too passes the MIL-PRF-44485 test for vibration.
<Request More Info> |
| If you have a specific application and need help determining which Analytic military battery charger is right for you, please CONTACT US, or Phone us (Toll-Free) at 1-800-668-3884. |
|
